Symmetricom 1100 User Manual

Chapter 4 Provisioning the TimeProvider

TP-SSU 03-05-15 09-59-09

A 1166 REPT EVT EQPT

“IMC,EQPT:FEATURE,TC,03-05-15 09-59-09,,,,:\”System 

Feature has been enabled\””

;

You use the Enter User Security command to add an SNMP user to the 
TimeProvider:

You use the Edit User Security command to change the security parameters, such 
as authentication protocol, authentication password, and privacy password.

You use the Retrieve User Security command to view the users connected to the 
TimeProvider.

You use the Delete User Security command to delete TL1 and SNMP users from 
the TimeProvider.

You can set up to five users to send out a trap, and up to five managers to receive 
the trap. You must also set up the timeout and retrry parameters for each 
user/manager. 

SNMP v1
To set up Traps, create an SNMP v1 community using the ENT-USER-SECU 
command. Add a MGRx and SENDERx using the ED-EQPT command. There is no 
Inform capability in SNMP v1. The engineid parameter in the ENT-USER-SECU 
command is ignored; the IFTOUTx and IFRETRYx parameters are not used.

SNMP v2C
To set up Notifications, create an SNMP v2C community using the 
ENT-USER-SECU command. Add a MGRx and SENDERx using the ED-EQPT 
command. Set the IFTOUTx and IFRETRYx parameters to 0.

To set up Informs, create an SNMP v2C community using the ENT-USER-SECU 
command. Add a MGRx and SENDERx using the ED-EQPT command. Set the 
IFTOUTx and IFRETRYx parameters to a nonzero value.