Acu-Rite CNC 3500i User Manual
172
7 Programming: Canned Cycles, sub-programs
7.
2 Canned Cy
cles
Rectangular Pocket Cycle
Use the rectangular pocket cycle to mill square or rectangular
pockets. You must position the tool directly over the center of the
pocket prior to the Rectangular Pocket cycle, or use the X Y data.
pockets. You must position the tool directly over the center of the
pocket prior to the Rectangular Pocket cycle, or use the X Y data.
Activate a tool prior to programming, so cutter diameter is known.
Field
Code
Description
Length
M
Length of pocket in X-axis. (Required)
Width
W
Width of pocket in Y-axis. (Required)
StartHgt
H
Z absolute starting height (0.1” or 2 mm
above surface). Executed in rapid.
(Required)
above surface). Executed in rapid.
(Required)
ZDepth
Z
Absolute depth of pocket. (Required)
StepOver
A
The distance the tool steps over (width of
cut) in the X and Y axes as it mills out the
pocket. Defaults to tool radius, which is the
max.
cut) in the X and Y axes as it mills out the
pocket. Defaults to tool radius, which is the
max.
XCenter
X
X coordinate of the pocket center point.
Defaults to current position.
Defaults to current position.
YCenter
Y
Y coordinate of the pocket center point.
Defaults to current position.
Defaults to current position.
CornerRad
U
The arc radius of all four corners of the
pocket. Defaults to tool radius, which is the
minimum value allowed.
pocket. Defaults to tool radius, which is the
minimum value allowed.
DepthCut
B
The depth of each cut per pass. Defaults to
tool diameter. Max is the full ZDepth in
parameter Z, less bottom finish stock. A
negative value will cause the finish pass to
finish the side walls in steps down.
tool diameter. Max is the full ZDepth in
parameter Z, less bottom finish stock. A
negative value will cause the finish pass to
finish the side walls in steps down.
FinStock
S
Amount of stock left by the roughing
passes for a finish pass. This amount
applies to the sides and bottom unless R
(SideStock) is defined; then, S (FinStock)
only applies to the bottom. Default is no
stock left.
passes for a finish pass. This amount
applies to the sides and bottom unless R
(SideStock) is defined; then, S (FinStock)
only applies to the bottom. Default is no
stock left.