SATO ct4i User Manual

 

This chapter provides guidance on how to station, connect, and load the printer once unpacked.  Following printer
setup, proceed to the next chapter for information on interface selection.

•

Station the printer on a solid flat surface.

•

Station it away from hazardous materials or dusty environments.

•

Station it within operational distance of the host computer, within interface cable specifications

The size and type of the labels or tags to be printed should have been taken into consideration before printer
purchase. Ideally, the media width will be equal to, or just narrower than, the print head. Using media that does not
cover the print head will allow the platen roller to tread on it and wear it out. The media edge will also wear a groove
in the platen roller affecting print quality.

There are two general label types that may be loaded and used; rolled and fan-folded. Each of those types may
again be defined by whether their print application is direct thermal or thermal transfer. Those factors determine
how the media is loaded and if ribbon stock is loaded at all.
Thermal transfer media requires the use of ribbon stock for print application. In such a scenario, it is the ribbon
stock (carbon paper) that contains the ink that will be transferred to the media. Direct thermal media has a coating
on the surface that is made visible through the application of heat from the print head. Rolled media of standard
diameter is loaded within the printer and suspended by the media holder. 

black roller