SATO ct4i User Manual

 

Fan-folded media is fed inward from the rear, via the rear housing cover  (highlighted in yellow below), but is
stacked as opposed to suspended. Ribbon can be wound in or wound out.

1.   Place the fanfold media behind the printer with the printing 

surface up. 

2.   Carefully pull up the Fanfold-label Loading Slot from the 

back of the Top Cover. 

3.   Open the Top Cover by pressing on the cover release latch 

located on the right-hand side of the printer. This releases 
the cover and allows it to swing upward on the rear- 
mounted hinges.

4.   With the Top Cover in the upright position, press the Paper 

Guide Release while adjusting the Paper Guides until they 
allow the media to fit between them. A millimeter scale is 
molded into the case to provide a guide when making the 
adjustment. The Paper Guides are center-justified and 
interact with each other so that each moves an equal dis-
tance apart from each other.

5.   Route the label material through the Sensor Assembly and 

over the Platen. See figure 3-4 for the label route.

6.   Close the Top Cover.

7.   After loading the label media, it is 

recommended that you run a Test Print to 
make sure the labels are correctly loaded 
and printed.