DYMO Rhino 5200 User Manual

14

You can choose to print 
labels with the text 
running vertically. Labels 
with multiple lines of text 
will print as multiple 
columns of text.
To create a vertical label
1. Press .
2. Enter or select a length 

for the label and press 

.

Select AUTO to have the length of the label 
automatically set to fit the text.

Once you create a label using one label type, you 
can easily change the label type without losing 
your data. 
If the data from one label type will not fit in the 
new label type, the text that will not fit is shaded 
in the display.
Example: When you change from a multi-cell 
label, such as a Patch Panel, to a single cell label, 
such as General or Flag, each cell becomes a new 
label. All blank cells are deleted.

When you change from a multi-cell label type 

to another multi-cell label type, make sure the new 
label type contains the same number of cells.
To change the label type
1. Press the hot key for the new label type.
2. Make any necessary adjustments to the settings 

for the label type.

Once you create a specific label, you can change 
the settings without starting all over again.
To change the label settings

1. Press .
2. Select Current label config. and press 

.

The settings for the particular label type 
are displayed.

3. Make the necessary changes.
4. Press 

 and then select Done (OK).

For multiple cell labels, such as Patch Panel, 
Electrical Panel, Terminal Block, 110-Block, and 
Module, you can choose to print a separator line 
between each of the cells.
To print separator lines between cells
1. Create the type of multiple cell label you want.
2. Press .
3. Select Current label config. and press 

.

4. Select Separator lines and press 

.

5. Select On.
6. Press 

 and then select Done (OK).

A line is printed between each cell. 

The printer can generate Code 39 and Code 128 
barcodes. You can add a barcode to the following 
label types:

You can only print a barcode on 3/4” (19 mm) wide 
labels. You can choose whether or not to print the 
human-readable text, and you can serialize 
barcodes.
The barcode prints horizontally along the label. You 
can choose to print the human-readable text in 
small print either underneath or above the 
barcode. Optionally, you can add text before and 
after the barcode.

The barcode text appears on the label in the 
display just like any other text. However, if the 
cursor is positioned within the barcode text, 
Barcode and the type of barcode are displayed in 
the Caption bar.
To add a barcode
1. Press  

+ 

.

2. Select Barcode type and press 

.

3. Select the barcode type, and press 

.

4. Enter the text for the barcode within the 

barcode on the display.

5. Press 

 and then select Done (OK).

General

Fixed

Wire

Patch Panel

Flag

Module

T

F

I

H

S