Ricoh 2000 User Manual

Specifying a Destination

53

❒ To send to a G3 fax via a gateway connected to a public telephone line, you

must specify it's the receiver's machine telephone number. For example, if the
receiver's fax number is “0312345678”, specify “5678”. To send from an IP-Fax
to G3 fax without using gatekeeper or SIP server, you must register the gate-
way also.

❒ When you specify a destination with IP-Fax, depending on the receiver's net-

work configuration, you may need to specify the IPv4 address and port num-
ber of the receiving machine. For example, if the receiver's IPv4 address is
“192.168.1.10” and the port number is “2100”, specify “192.168.1.10:2100”.
Ask the network administrator for details.

❒ When you specify a host name, depending on the receiver's network config-

uration, you may need to specify the host name and port number of the re-
ceiving machine. For example, if the receiver's host name is “IPFAX1”and the
port number is “2100”, specify “IPFAX1:2100”. Ask the network administra-
tor for details.

❒ An alias telephone number is a number that is registered in the gatekeeper,

and is available only in the network to which the gatekeeper is connected.

❒ Pay attention to the number of telephone number digits set in the gate-

way/IPv4 address conversion table to avoid transmission error.

This section explains how to specify an e-mail address as a destination.
When using Internet Fax transmission, specify the e-mail address in place of the
fax number.

❒ To use Internet Fax functions, the optional printer/scanner unit must be installed.
❒ In the destination list, register senders, specify their e-mail addresses, and

register as [Sender Only] or [Dest. & Sender] in advance using “Address Book
Management” in “System Settings”.

❒ Internet Fax is executed in only Memory Transmission that starts transmis-

sion automatically after storing documents in memory. If you specify Imme-
diate Transmission in Internet Fax, the “

Try again after switching to

memory transmission.

” message appears. When this happens, press [Exit],

and then switch to Memory Transmission.

A