Panasonic KX-FC962HK User Manual
3. Preparation
19
3.6 Adjusting base unit
volume
volume
Ringer volume
While the unit is idle, press {A} or {B}.
L
If any documents are in the document
entrance, you cannot adjust the volume.
Confirm that there are no documents in the
entrance.
entrance, you cannot adjust the volume.
Confirm that there are no documents in the
entrance.
To turn the ringer OFF
1. Press {B} repeatedly to display “
RINGER
OFF= OK?”.
2. Press {SET}.
L
When a call is received, the base unit will not
ring for outside calls and will display
“
ring for outside calls and will display
“
INCOMING CALL”. The base unit will ring at
the low level for intercom calls.
L
To turn the ringer back ON, press {A}.
Ringer type
L
You can select the ringer types from one of 6
types for outside calls (feature #17 on page
62).
types for outside calls (feature #17 on page
62).
Handset receiver volume
While using the handset, press {A} or {B}.
Speaker volume
While using the speakerphone, press {A} or
{B}
{B}
.
Answering machine volume
While listening to messages, press {A} or
{B}
{B}
.
Initial Programming
3.7 Dialling mode
3.7.1 With the cordless handset
1
Press {j/OK}.
2
Select “
Base Unit Setup”, then press
{>}
.
3
Enter “
0000” (default base unit PIN).
L
If you changed the PIN, enter it (page 73).
4
Select “
Call Options”, then press {>}.
5
Select “
Dial Mode”, then press {>}.
6
Select the desired setting, then press {>}.
–
–
“
Tone” (default): For tone dial service.
–
“
Pulse”: For rotary pulse dial service.
7
Press {ih}.
3.7.2 With the base unit
1
Press {MENU}.
SYSTEM SETUP
PRESS [( )]
2
Press {<} or {>} repeatedly to display the
following.
following.
DIALLING MODE
=TONE
[±]
{A}{B}
{
SET}
{ih}
{j
/OK}
{>}
{A}{B}{<}{>}
{
MENU}
{
SET}
FC962HK-PFQX2283ZA-en.book Page 19 Thursday, September 15, 2005 4:20 PM