Allied Telesis AT-MC606 User Manual

AT-MC606 VDSL Network Extender Installation Guide

35

5. Go to “Cabling the Subscriber Unit” on page 35 to connect the cables 

and to “Powering On the Subscriber Unit” on page 37 for powering the 
unit.

The AT-MC606 VDSL Network Extender may be wall mounted directly to 
the wall with an AT-WLMT Wall Mount Bracket or by using an Allied 
Telesis DINRAIL Bracket (both supplied separately) in conjunction with a 
previously mounted DINRAIL. 

1. Configure the right VDSL CONFIG switch (SCBR/PROV) to the SCBR 

position as shown in Figure 8, ”Configuring AT-MC606 Ethernet 
Extender for Subscriber Mode” on page 34.

2. Follow the installation instructions supplied with the wall mounting 

bracket.

3. Go to “Cabling the Subscriber Unit” on page 35 to connect the cables 

and to “Powering On the Subscriber Unit” on page 37 for powering the 
unit.

To cable the Subscriber unit to a computer, perform the following steps:

1. Connect the Ethernet cable from the AT-MC606 Ethernet port to the 

Ethernet port on your computer, as shown in Figure 9.

Figure 9. Connecting AT-MC606 Ethernet Port to Computer

1937

VDSL

 EXTE

NDED E

THERN

ET