Netgear FVS318N User Manual

Click OK. A message similar to the following should display:

Pinging <IP address> with 32 bytes of data

If the path is working, you see this message:

Reply from <IP address>: bytes=32 time=NN ms TTL=xxx

If the path is not working, you see this message:

Request timed out

If the path is not functioning correctly, you could have one of the following problems:

Wrong physical connections

Make sure that the LAN port LED is on. If the LED is off, follow the instructions in 

on page 380.

Check that the corresponding Link LEDs are on for your network interface card 
and for the hub ports (if any) that are connected to your workstation and wireless 
VPN firewall.

Wrong network configuration

Verify that the Ethernet card driver software and TCP/IP software are both 
installed and configured on your computer or workstation.

Verify that the IP address for your wireless VPN firewall and your workstation are 
correct and that the addresses are on the same subnet.

Test the Path from Your Computer to a Remote Device

After verifying that the LAN path works correctly, test the path from your computer to a remote 
device. From the Windows Run dialog box, type:

in which <IP address> is the IP address of a remote device such as your ISP’s DNS 
server.

If the path is functioning correctly, replies as in the previous section are displayed. If you do 
not receive replies:

Check that your computer has the IP address of your wireless VPN firewall listed as the 
default gateway. If the IP configuration of your computer is assigned by DHCP, this 
information is not visible in your computer’s Network Control Panel. 

Check to see that the network address of your computer (the portion of the IP address 
that is specified by the netmask) is different from the network address of the remote 
device.

Check that the modem, dish, or router is connected and functioning.

For IPv4 connections, if your ISP assigned a host name, system name, or account name 
to your computer, enter that name in the Account Name field on the Broadband ISP 
Settings (IPv4) screen. You might also have to enter the assigned domain name or 
workgroup name in the Domain Name field, and you might have to enter additional