ONKYO ABX-N300 User Manual

En-

27

• You’ll use the remote controller to perform these 

operations.

• Network settings are made while the ABX-N300 is in 

standby mode. If the ABX-N300 is powered-on, press 
the [] button to put it in standby mode.

• When setting up a wireless network connection, you’ll 

need to enter the authentication method and security 
key. Have these settings ready before you begin.

• Unfold the Wireless LAN antenna located on the back 

of the ABX-N300.

Disconnect the AC adapter, wait at least ten 
seconds, and then reconnect the AC 
adapter.
Do not connect the Ethernet cable. If it is 
connected, disconnect the Ethernet cable and the 
AC adapter, and wait at least ten seconds before 
reconnecting only the AC adapter.

Use the []/[] buttons to select “Standby 
Mode,” and press the [ENTER] button; then 
use the []/[] buttons to select “Network,” 
and press the [ENTER] button.

Use the []/[] buttons to select “Network 
Setup,” and press the [ENTER] button.
Wait until the “Connection” indication appears.

Are you connecting to the 
network by a cable or by a 
wireless connection?

Wireless

Cable

Yes

No

Yes

No

Yes

No

Do you have a wireless LAN 
router?

Do you have a router, or a modem 
that includes router functionality?

See “Connecting via 
Wireless LAN” below.

Obtain a wireless LAN 
router.

Is DHCP enabled on your 
router or router-capable 
modem?

Obtain a router.

See “Network 
connections (DHCP)” on 
page 28.

See “Network 
connections (Manual)” 
on page 29.

Network Setup 

    

 Network Info
 Standby Mode

     Beep

Standby Mode 

    

  

   Network

 Network Setup

    

    Ethernet

   Connection