TAG 20 User Manual

Page of 147
 
 
vii
On the Use of RF Device 
NOTE: The information in this section applies to models with the wireless LAN module. 
USA and Canada Safety Requirements and Notices 
IMPORTANT NOTE: To comply with FCC RF exposure compliance 
requirements, the antenna used for this transmitter must be installed to 
provide a separation distance of at least 20 cm from all persons and must 
not be co-located or operating in conjunction with any other antenna or 
transmitter. 
Radio Frequency Interference Requirements and SAR 
The FCC with its action in ET Docket 93-62 has adopted a safety standard 
for human exposure to Radio Frequency (RF) electromagnetic energy 
emitted by FCC certified equipment. The wireless LAN module meets the 
Human Exposure limits found in OET Bulletin 65, 2001, and ANSI/IEEE 
C95.1, 1992. Proper operation of this radio according to the instructions 
found in this manual will result in exposure substantially below the 
FCC’s recommended limits. The following safety precautions should be 
observed: 
 
Do not touch or move antenna while the unit is transmitting or 
receiving. 
 
Do not hold any component containing the radio such that the antenna 
is very close or touching any exposed parts of the body, especially the 
face or eyes, while transmitting. 
 
Do not operate the radio or attempt to transmit data unless the antenna 
is connected; if not, the radio may be damaged. 
Use in specific environments: 
 
The use of wireless devices in hazardous locations is limited by the 
constraints posed by the safety directors of such environments.