Avaya Wireless AP-3 User Manual

Avaya Wireless AP-3 User’s Guide                                                                                 7-19

NOTE:
This does not delete the AP’s configuration (in other words, the 
Forced Reload Procedure does not reset to device to factory 
defaults). If you need to force the AP to the factory default state after 
loading a new AP image, use the 

For this procedure, you will first erase the AP Image currently installed on 
the unit and then use either ScanTool or the Bootloader CLI (over the 
serial port) to set the IP address and download a new AP Image. Follow 
these steps:

1. While the unit is running, press the RESET button.

NOTE:
See 

 to identify the buttons. You need 

to use a pin or the end of a paperclip to press a button.

Result: The AP reboots and the indicators begin to flash.

!

By completing Step 2, the firmware in the AP will be erased. You will need 
an Ethernet connection, a TFTP server, and a serial cable (if using the 
Bootloader CLI) to reload firmware.

2. Press and hold the RELOAD button for about 20 seconds until the 

POWER LED turns amber. 

Result: The AP deletes the current AP Image.