Avocent MPX1000 User Manual

 Chapter 4: Additional Functions        49

7.

Press the 

 button to complete the operation. The settings will be applied immediately if 

Yes was selected and the settings were valid. Otherwise, the current configuration will not be 
altered. In either case, you will be returned to top level of the Configure Control LAN menu.

Press the 

 button to return to the Avocent logo or the 

 and 

 buttons to scroll through the 

top level menu.

NOTE: Front panel configuration may be disabled via the transmitter’s web interface. By default, front panel 
configuration is enabled. This setting may be changed in the System Settings page.

The front panel display has a screen saver that automatically comes on if no buttons are pressed for 
30 consecutive minutes. When the screen saver is active, it horizontally scrolls the current screen 
off the left edge of the display while scrolling in a blank screen from the right. The process repeats 
every four seconds.

While the screen saver is active, updates to the content of the display occur only during the four 
seconds that the screen stops in the center of the display. Automatic (timed) updates to the contents 
of the screen are delayed while the screen is actively scrolling, and will not occur until the screen 
reaches its center position. This lets you see every automatic status update, even if the screen saver 
is active while the RxStatus is in scan mode.

Press any key while the screen saver is active to immediately stop the screen saver and display the 
current screen in its normal (centered) position on the front panel.