Network Technologies ASI-IP-GTW User Manual

ASI-IP-GTW User's Manual 

 

 Page 

23 

Table 7. Optional SFP Ethernet data port 

 
Note: Please note that the optional SFP slot always provide Gigabit 
Ethernet. Other bitrates are not supported by the SFP slot. 
Note: Please note that data will not be available simultaneously on the 
electrical Ethernet port and the SFP slot. Through the user interface 
the user selects on which port the data should be available. 

The ASI-IP-GTW is provided with an Ethernet management port for 
configuration and control. The interface is 100Base-T. Please connect 
the management port to the appropriate LAN for configuration and 
control. 

Table 8. Ethernet management port  

 
Two LEDs are associated with the Ethernet management port.  

The ASI-IP-GTW is equipped with 4 LEDs at the front. The following 
table describes the meaning of the front LEDs.  
 

Table 9. Front panel LEDs 

 
The front LEDs are replicated at the rear panel. 
Each ASI port has two LEDs associated with it.  

Type                

Gigabit Ethernet, Small Form-Factor Pluggable 
(SFP) slot to carry copper or optical SFP, 
compatible with approved modules conforming to 
the Small Form-factor Pluggable Transceiver 
MultiSource agreements (Sept.14, 2000). 

Optical interface must comply with safety 
requirements IEC 60825 (Class 1) and 21 CFR 
1040.10 & 1040.11 (Class 1). 

Safety status 

SELV 

Type                

10/100Base-T 

Connector type 

RJ45 

Power 

Green 

This LED is lit when power is being received by the 
unit. 

Alarm 

Red 

This LED is lit when a failure is detected by the unit. 

IP TX 

Blue 

This LED is lit when the unit is configured to transmit 
data to the IP Network. 

IP RX 

Yellow 

This LED is lit when the unit is configured to receive 
data from the IP Network