Network Technologies ASI-IP-GTW User Manual

ASI-IP-GTW User's Manual 

 

 Page 

24 

 

Table 10. ASI port LEDs 

 
Each Ethernet port (data and management) has two LEDs associated 
with it.  

Table 11. Ethernet port LEDs 

 

Before powering-up the unit, please check the following: 

o 

The unit is installed in a suitable location 

o 

The unit has been connected to external equipment as required 

Power up the unit by inserting the power cable connected to a power 
source.  
The cooling fans will start up in a full-speed mode. When the unit has 
finished the start-up procedure, the fans will run at normal speed. 
Please check that the all cooling fans are rotating. If they are not, 
switch of the unit immediately.  

To power down the unit, remove the power supply connection at the 
rear of the unit.  
 

Unlit Unlit  Input 

disabled (ASI input) 

Lit 

Unlit 

Input enabled, no ASI stream detected (not in 
sync) 

IP Tx 

Lit 

Lit 

Input enabled, ASI stream detected (in sync) 

Unlit Unlit  Output 

disabled (ASI output) 

IP Rx 

Unlit Lit 

Output 

enabled 

Green Lit 

when 

link 

 

Blinks when data is transmitted or received. 

Unlit 10Mbit/s 

Green 100Mbit/s 

Yellow 1000Mbit/s