National Instruments NI PCIe-8361 User Manual
Appendix C
Advanced Hardware Configuration Settings
C-6
ni.com
•
Set the W3 jumper to TRIG/CLK PORT A(B), shown
in Figure C-5b, to select the CLK10 source as the
TRIG/CLK PORT A(B) on the VXI-8360T front panel. When
selecting the trigger card as the CLK10 input source be sure
to set jumper W7 to set the direction of CLK10 through the
TRIG/CLK PORT A(B).
in Figure C-5b, to select the CLK10 source as the
TRIG/CLK PORT A(B) on the VXI-8360T front panel. When
selecting the trigger card as the CLK10 input source be sure
to set jumper W7 to set the direction of CLK10 through the
TRIG/CLK PORT A(B).
Figure C-5. Selecting the External CLK10 Source with the W3 Jumper
W4—CLK10 Source Select
In Slot 0 operation the CLK10 Source Select jumper allows you to select
the source for the VXIbus CLK10 that is routed to the backplane.
the source for the VXIbus CLK10 that is routed to the backplane.
The default setting, Internal Oscillator, shown in Figure C-6a, uses the
internal 10MHz ±100 ppm oscillator as the VXIbus CLK10 source.
internal 10MHz ±100 ppm oscillator as the VXIbus CLK10 source.
Set the W4 jumper to External Source, shown in Figure C-6b, to use the
front panel SMB or the TRIG/CLK PORT A(B) as the CLK10 source.
Jumper W3 External CLK10 Source Select is used in conjunction with W4
when W4 is set to select an external oscillator as the VXIbus CLK10
source.
front panel SMB or the TRIG/CLK PORT A(B) as the CLK10 source.
Jumper W3 External CLK10 Source Select is used in conjunction with W4
when W4 is set to select an external oscillator as the VXIbus CLK10
source.
Figure C-6. Selecting the CLK10 Source with the W4 Jumper
a. Front Panel
SMB Connector
(Default)
b. Front Panel
TRIG/CLK PORT
When W3 is set to select the
TRIG/CLK PORT as the CLK10
source, use jumper W7 to set
the direction of CLK10 through
the TRIG/CLK PORT.
TRIG/CLK PORT as the CLK10
source, use jumper W7 to set
the direction of CLK10 through
the TRIG/CLK PORT.
1
2
3
1
2
3
W3
W3
a. Internal
10 MHz
Oscillator
(Default)
b. External
10 MHz
Source
When W4 is set to select an external
CLK10 source, use jumper W3 to select
between the front panel SMB connector
or the TRIG/CLK PORT A(B).
CLK10 source, use jumper W3 to select
between the front panel SMB connector
or the TRIG/CLK PORT A(B).
W4
W4
1
2
3
1
2
3