National Instruments NI PCIe-8361 User Manual
Appendix C
Advanced Hardware Configuration Settings
C-8
ni.com
Figure C-8. Inverting the CLK10 Signal through MAX
CLK10 Termination
If the front panel SMB connector EXT CLK is configured as an input
this software setting can enable 50
this software setting can enable 50
Ω parallel termination. This setting
can be found in the hardware configuration panels in MAX, as shown in
Figure C-8.
Figure C-8.
Trigger Input Termination
Optional software enabled 50
Ω parallel termination is available for the
front panel trigger input. This setting can be found in the hardware
configuration panels in MAX, as shown in Figure C-8.
configuration panels in MAX, as shown in Figure C-8.
Note
Parallel termination is not necessary when the signal is driven by a 50
Ω source, such
as a VXI-MXI-Express Series controller.