NEC NDA-30115-001 User Manual
Page 32
NDA-30115 Revision 1.0
Message Formats
Property Management System - Communication Interface
Note 3:
In the case of messages that are almost identical, the FC will be marked with
“**”. Also, differing FTC values will be marked with “*”. The final message is
then constructed by simply inserting the desired FC value (and, if necessary, the
desired FTC value).
“**”. Also, differing FTC values will be marked with “*”. The final message is
then constructed by simply inserting the desired FC value (and, if necessary, the
desired FTC value).
All messages in this section have been previously defined in NEAX2400 IMS Hotel
System PMS Interface Specification (except for one Maid Status message, which is
so noted). The versions supported are Model 60 and Model 90; Model 120
messages are not supported. Any message that is intended to work with only one
version is so designated; any message that is intended to work with both has no
special designation.
System PMS Interface Specification (except for one Maid Status message, which is
so noted). The versions supported are Model 60 and Model 90; Model 120
messages are not supported. Any message that is intended to work with only one
version is so designated; any message that is intended to work with both has no
special designation.
The Feature Codes used are as follows:
•
70 -- Data Link Maintenance
•
11, 12, 51, 52 -- Maid Status
•
13, 53 -- Message Waiting Lamp Control
•
15 -- Restriction Control
•
16 -- Check-In/Out (Model 60)
•
56 -- Check-In/Out (Model 90)
•
19 -- Wake Up/Group Announcement
•
20 -- Room Move/Swap/Copy (Model 60)
•
21, 61 -- Room Data Change
•
17 -- Extension Report
•
17 -- Room Recovery (Model 60)
•
57 -- Room Recovery (Model 90)
•
59 -- Direct Data Entry (Model 90)
•
62 -- Extension Connection
Data Link Maintenance
These messages are used by the NEAX and the PMS to maintain the data link
between them. The messages are as follows:
between them. The messages are as follows:
•
70-0 -- Nop Test Normal Answer (Sent by NEAX)
•
70-2 -- Nop Test Recover Answer (Sent by NEAX)
•
70-3 -- Recovery Start Report (Sent by PMS)
•
70-4 -- Recovery End Report (Sent by PMS)
•
70-5 -- Data Link Release Request (Sent by PMS and NEAX)
•
70-6 -- Data Link Release Confirmation. (Sent by PMS and NEAX)
•
70-8 -- Extension Number Request (Sent by PMS)
•
70-F -- Nop Test (Sent by PMS)