Nortel Networks 201i User Manual
November 2006
Installing the 201i server in the Succession 1000 system
201i Server Hardware Installation
107
Installing the 201i server
Introduction
This section describes how to install the 201i server inside the Media
Gateway or Media Gateway Expansion.
Gateway or Media Gateway Expansion.
Before you begin
Determine which pair of consecutive slots are to contain the 201i server. The
following table identifies the Media Gateway and Media Gateway
Expansion slots into which the CallPilot 201i server can be installed:
following table identifies the Media Gateway and Media Gateway
Expansion slots into which the CallPilot 201i server can be installed:
Note: The 201i server will not function properly when installed in slots 3
and 4.
and 4.
For more information about card slots, refer to the Succession 1000
Planning and Installation Guide (NTP 553-3023-210).
Planning and Installation Guide (NTP 553-3023-210).
For the logical slot numbers that you must use when you configure the
Succession 1000 system, see “Card slots” on page 97.
Succession 1000 system, see “Card slots” on page 97.
Unit
The 201i server
can be installed in
can be installed in
Ineligible slots
Media Gateway
Slots 1 and 2
Slots 2 and 3
Slot 0 is dedicated to the SSC card.
Slot 4 (includes slots 5 and 6) is
not used.
not used.
Media Gateway
Expansion
Expansion
Slots 7 and 8
Slots 8 and 9
Slots 9 and 10
Slot 10 is a double-wide slot. The
second half of this slot does not
have a backplane connector.
second half of this slot does not
have a backplane connector.