Nortel Networks 703t User Manual

Preinstallation requirements

Standard 1.04

CallPilot

Inspecting the server interior

Introduction

Before you install the server, you should perform a visual inspection for
loose components, foreign matter, or shipping damage inside the server.

To inspect the server interior

1 Ensure that all the cards are fully seated on the baseboard.

2 Check for any loose wires or foreign objects, such as loose screws,

inside the chassis.

3 Review the slot locations (see “Rear panel diagram” on page 21).

4 Do one of the following:

CAUTION

Risk of equipment damage

When working with interior components, use an ESD wrist
strap to protect static-sensitive components.

IF THEN

you observe
any damage

contact your Nortel technical support
representative.

components have
become loose

secure them. Then replace the server
side cover and proceed with the
hardware installation.

Refer to the procedures in CallPilot 703t
Server Maintenance and Diagnostics
(555-7101-227).

you are satisfied that the
703t server has arrived at
your site undamaged

replace the server side cover.