Nortel Networks 4050 User Manual
464 Chapter 10 Configuring system settings
320818-A
Configuring system settings using the CLI
To view and configure cluster-wide system settings, use the following command:
/cfg/sys
The System menu displays.
The System menu includes the following options:
/cfg/sys
followed by:
mip <IPaddr>
Sets the MIP for the cluster. The MIP identifies the
cluster and must be unique on the network. For more
information, see
cluster and must be unique on the network. For more
information, see
Note: Nortel does not recommend reconfiguring this
parameter if you are logged on to the MIP, because you
may lose connectivity. To reset the MIP, log on to the
RIP instead.
parameter if you are logged on to the MIP, because you
may lose connectivity. To reset the MIP, log on to the
RIP instead.
host <host ID>
Accesses the Cluster Host menu, in order to configure
a specific Nortel SNAS 4050 host (see
a specific Nortel SNAS 4050 host (see
routes
Accesses the Routes menu, in order to manage static
routes for the cluster when there is more than one
interface (see
routes for the cluster when there is more than one
interface (see
time
Accesses the Date and Time menu, in order to
configure date and time settings and to access Network
Time Protocol (NTP) servers (see
configure date and time settings and to access Network
Time Protocol (NTP) servers (see
dns
rsa <server ID>
Accesses the RSA Servers menu, in order to configure
the RSA server (see
the RSA server (see
Note: Not supported in Nortel Secure Network Access
Switch Software Release 1.0.
Switch Software Release 1.0.
syslog
Accesses the Syslog Servers menu, in order to
configure the Syslog servers for receiving log
messages (see
configure the Syslog servers for receiving log
messages (see
).