EMC QLA22xx User Manual
2
2-12
Installing and Configuring the HBA Driver
Manually Setting the
HBA Data Rate
HBA Data Rate
The HBA driver for a QLA2310 has a data rate setting that lets you
specify 1 Gb, 2 Gb, or Auto Select mode. (The EMC default setting is
Auto Select mode.)
specify 1 Gb, 2 Gb, or Auto Select mode. (The EMC default setting is
Auto Select mode.)
For any device connected to the HBA, set the device data rate (if applicable)
before setting the HBA data rate.
before setting the HBA data rate.
Current 64-bit systems can be updated only from within Windows 2003 using
the SANSurfer SANBlade Manager. Refer to QLogic SANSurfer SANBlade
Manager v2.0.21 on page A-2 for instructions.
the SANSurfer SANBlade Manager. Refer to QLogic SANSurfer SANBlade
Manager v2.0.21 on page A-2 for instructions.
For every HBA on which you want to manually set the HBA data
rate, follow these steps.
rate, follow these steps.
1. Reboot the system.
2. At startup, watch for the QLogic BIOS screen and when
prompted to enter Fast!Util, press
CTRL-Q
.
3. Select host adapter.
4. Select Configuration Settings.
5. Select Extended Firmware Settings.
6. Press the Down Arrow until you select Data Rate; then press
ENTER
.
7. Select the appropriate speed for the device to which the HBA
connects. EMC recommends using the default setting of option 2,
Auto Select.
Auto Select.
8. Press
ESC
repeatedly until you reach the
Save Changes
prompt,
and save the changes for this adapter.