ZyXEL Communications P-660R-T Series User Manual

P-660R-T Series User’s Guide

231 

Chapter 28 IP Policy Routing

Figure 156   Menu 25.1.1 IP Routing Policy

                         Menu 25.1.1 - IP Routing Policy

          Policy Set Name= test
          Active= Yes
          Criteria:
            IP Protocol    = 6
            Type of Service= Normal         Packet length= 40
            Precedence     = 0               Len Comp= Not Equal
            Source:
              addr start= 1.1.1.1            end= 1.1.1.1
              port start= 20                 end= 20
            Destination: 
              addr start= 2.2.2.2           end= 2.2.2.2
              port start= 20                 end= 20
          Action= Matched
            Gateway addr   = 192.168.1.1    Log= No
            Type of Service= Max Thruput
            Precedence     = 0

Press ENTER to Confirm or ESC to Cancel:

The following table describes the fields in this menu.

Table 73   Menu 25.1.1 IP Routing Policy 

Policy Set Name

This is the policy set name assigned in Menu 25 – IP Routing Policy Setup.

Active

Press [SPACE BAR] and then [ENTER] to select Yes to activate or No to 

deactivate the policy. Inactive policies are displayed with a minus sign “-“ in SMT 

menu 25.

Criteria

IP Protocol

IP layer 4 protocol, for example, UDP, TCP, ICMP, etc.

Type of Service

Prioritize incoming network traffic by choosing from Don’t Care, Normal, Min 

Delay, Max Thruput, Min Cost or Max Reliable.

Precedence

Precedence value of the incoming packet. Press [SPACE BAR] and then 

[ENTER] to select a value from 0 to 7 or Don’t Care.

Packet Length

Type the length of incoming packets (in bytes). The operators in the Len Comp 

(next field) apply to packets of this length.

Len Comp

Press [SPACE BAR] and then [ENTER] to choose from Equal, Not Equal, 

Less, Greater, Less or Equal or Greater or Equal.

Source:

addr start / end

Source IP address range from start to end.

port start / end

Source port number range from start to end; applicable only for TCP/UDP.

Destination:

addr start / end

Destination IP address range from start to end.

port start / end

Destination port number range from start to end; applicable only for TCP/UDP.

Action

Specifies whether action should be taken on criteria Matched or Not Matched.