ZyXEL Communications Omni.Net Lite User Manual
Omni.Net Lite User’s Guide
Chapter 2 Using the Utility
50
Figure 18 Analog Port: Supplementary Service
2.12.4.4 Call Transfer
You can transfer a call to a local phone (connected to the TA) or a remote phone (not
connected to the TA) through an ISDN line.
connected to the TA) through an ISDN line.
2.12.4.4.1 Call Transfer between Two Analog Ports
To transfer incoming calls (after you answer this call) to a local phone, follow these steps:
1 Press the flash key to put the caller on hold.
2 When you hear the dial tone, dial “1#” to operate the Intercom.
3 After you hear the ring signal or the second party answer it, press the flash key, then “4”.
4 Hang up the phone.
2.12.4.4.2 Call Transfer to a Remote Phone
To transfer incoming calls (after you answer this call) to a remote phone, follow these steps:
1 Press the flash key to put the caller on hold.
2 When you hear the dial tone, simply dial the number you want, to transfer the first call.
3 After you hear the ring signal or the second party answer it, press the flash key, then “4”.