ZyXEL Communications Omni.Net Lite User Manual

Omni.Net Lite User’s Guide

61

Chapter 3 Using AT Commands

The AT command sets for debugging are shown in the following table.

This section shows you some examples of configuring the TA using AT commands. 

!pS=<phone 

number> [/<sub-

address>]

Assign you phone number to the analog port.
p: enter 1 or 2 to specify the analog port.
<phone number>: Enter up to 32 characters, including digits from 0 to 9, *, #, 

hyphen ( -), comma (,) and (‘,’).  [‘,’] will be ignored.
<sub-address>: Enter up to 20 ASCII characters ranging from “0-9”,” a-z” and 

“A-Z”.

$D99

Upgrade firmware.

$C0?

Display the charge information of the last call.
Use $C0=0 to clear the information. 

$C1?

Display the accumulative charge information of the calls.
Use $C0=1 to clear the information. 

$F99

Reset all parameters to the factory defaults. 

$P5=<country 

selection code>

Set three-digit country code for caller ID signaling (FSK or DTMF).
The default is 216.

Table 15   AT Command Sets for the Analog Port

Table 16   Debug Command Sets

#C0 Clear 

frame 

logs.

#Dn

Display frame logs or internal task status.
n=80: display frame logs.
n=82: display C/I code (layer 1 signal) logs.

L6=n

Set the level of frame logs to Q.921.
n=0: disable frame logging.
n=1: enable signal frame logging.
n=2: enable full frame logging.

L8=n

Set the level of frame logs to V.120, X.75.
n=0: disable frame logging.
n=1: enable signal frame logging.
n=2: enable full frame logging.

L13=n

Set the level of frame logs to PPP.
n=0: disable frame logging.
n=1: enable signal frame logging.
n=2: enable full frame logging.