ZyXEL Communications VSG-1000 User Manual

VSG-1000 Vantage Service Gateway

15-4

Troubleshooting

Figure 15-2 SMT: Debug Mode: Erasing Firmware

4. Enter 2 to restart the VSG.

Figure 15-3 SMT: Debug Mode: Restarting the VSG

5. After the VSG restarts, a screen displays prompting you to specify the initial settings for TFTP file

transfer. The default settings are displayed in the brackets.
For VSG settings, specify the IP address, subnet mask and default gateway. For TFTP server settings,
enter the IP address and the firmware file name.

Make sure the IP addresses are in the same range.

Figure 15-4 SMT: Debug Mode: Specifying Initial VSG and TFTP Settings

6. Verify the settings and enter n. Otherwise enter y to change the settings again.

(1)Run Monitor
(2)Restart system
(3)Erase entire FLASH
(4)SDRAM Testing

Enter selection:3
Erasing flash 0 block 0...OK
Erasing flash 0 block 1...OK
Erasing flash 0 block 2...OK
Erasing flash 0 block 3...OK
Erasing flash 0 block 4...OK

…

Erasing flash 0 block 16...OK
Erasing flash 0 block 17...OK
Erasing flash 0 block 18...OK
Erasing flash 0 block 19...OK
Erasing flash 0 block 20...OK
Erasing flash 0 block 21...OK
Erasing flash 0 block 22...OK

-------------------------------------------------
Please enter TFTP related parameters:

IP address[192.168.1.254]:10.59.1.1
TFTP server IP address[192.168.1.253]:10.59.1.33
Gateway IP address[192.168.1.1]:10.59.1.33
Subnet mask[255.255.255.0]:255.0.0.0
File name[IBOX.BIN]:VSG1000-10303.bin

(1)Run Monitor
(2)Restart system
(3)Erase entire FLASH
(4)SDRAM Testing

Enter selection:2

Restarting...