ZyXEL Communications WAP3205 User Manual

Chapter 13 Troubleshooting

WAP3205 User’s Guide

I cannot access the Internet.

Check the hardware connections, and make sure the LEDs are behaving as 
expected. See the Quick Start Guide.

Make sure the WAP3205 is connected to a broadband modem or router with 
Internet access. 

If you are trying to access the Internet wirelessly, make sure the wireless settings 
in the wireless client are the same as the settings in the AP.

• Go  to  Network > Wireless LAN > General > WDS and check if the 

WAP3205 is set to bridge mode. Select Disable and try to connect to the 

Internet again.

Disconnect all the cables from your device, and follow the directions in the Quick 
Start Guide again. 

Go to Maintenance > Sys OP Mode. Check your System Operation Mode 
setting. 

• Select Access Point Mode if your WAP3205 bridges traffic between clients on 

the same network. 

• Select Client Mode if your WAP3205 needs a wireless client to connect to an 

existing access point.

• Select Universal Repeater Mode if you want to have wireless clients 

associate with the WAP3205 and also want to connect the WAP3205 to an 

existing access point.

If the problem continues, contact your ISP.

I cannot access the Internet anymore. I had access to the Internet (with the 
WAP3205), but my Internet connection is not available anymore.

Check the hardware connections, and make sure the LEDs are behaving as 
expected. See the Quick Start Guide and 

Reboot the WAP3205.

If the problem continues, contact your ISP.