ZyXEL Communications WAP3205 Manual De Usuario
Chapter 13 Troubleshooting
WAP3205 User’s Guide
122
13.3 Internet Access
I cannot access the Internet.
1
Check the hardware connections, and make sure the LEDs are behaving as
expected. See the Quick Start Guide.
expected. See the Quick Start Guide.
2
Make sure the WAP3205 is connected to a broadband modem or router with
Internet access.
Internet access.
3
If you are trying to access the Internet wirelessly, make sure the wireless settings
in the wireless client are the same as the settings in the AP.
in the wireless client are the same as the settings in the AP.
• Go to Network > Wireless LAN > General > WDS and check if the
WAP3205 is set to bridge mode. Select Disable and try to connect to the
Internet again.
4
Disconnect all the cables from your device, and follow the directions in the Quick
Start Guide again.
Start Guide again.
5
Go to Maintenance > Sys OP Mode. Check your System Operation Mode
setting.
setting.
• Select Access Point Mode if your WAP3205 bridges traffic between clients on
the same network.
• Select Client Mode if your WAP3205 needs a wireless client to connect to an
existing access point.
• Select Universal Repeater Mode if you want to have wireless clients
associate with the WAP3205 and also want to connect the WAP3205 to an
existing access point.
6
If the problem continues, contact your ISP.
I cannot access the Internet anymore. I had access to the Internet (with the
WAP3205), but my Internet connection is not available anymore.
WAP3205), but my Internet connection is not available anymore.
1
Check the hardware connections, and make sure the LEDs are behaving as
expected. See the Quick Start Guide and
expected. See the Quick Start Guide and
2
Reboot the WAP3205.
3
If the problem continues, contact your ISP.