ZyXEL Communications PLA-407 User Manual
Chapter 4 The ENCRYPT Button
PLA-407 User’s Guide
32
4
Press the ENCRYPT button on your second Powerline device for 1~2 seconds. The
power (
power (
) light will blink as the PLA-407 tries to set up a connection.
Figure 10 ENCRYPT Connection Procedure
Note: The ENCRYPT button’s location varies for each Powerline device.
5
in this section for any other Powerline device you wish to connect.
This must be done within 60 seconds of pressing the ENCRYPT button on the
PLA-407.
PLA-407.
6
Check the lights on the Powerline devices. The power (
) and HomePlug (
)
lights should be blinking while the devices are connecting. Several times all lights
blink simultaneously and the HomePlug (
blink simultaneously and the HomePlug (
) light also shows red. Wait for about
one minute while your Powerline devices connect.
If the power (
) light does not blink when you press ENCRYPT, you have
probably pressed the ENCRYPT button for too long. Try again, pressing the
ENCRYPT button for 1~ 2 seconds.
ENCRYPT button for 1~ 2 seconds.
If the HomePlug (
) lights on both Powerline devices do not light up, the
Powerline devices are not connected. Repeat steps 4 and 5 in this section. If
that doesn’t work, see the Troubleshooting in Section 9.5 on page 82 for
suggestions.
that doesn’t work, see the Troubleshooting in Section 9.5 on page 82 for
suggestions.
within 2 minutes
press for
2 seconds
press for
2 seconds
2 seconds