ZyXEL Communications 4528F User Manual

 Chapter 42 VRRP

XGS-4526/4528F/4728F User’s Guide

The following sections describe the different parts of the VRRP Configuration 
screen.

Before configuring VRRP, first create an IP interface (or routing domain) in the IP 
Setup screen (see the 

 for more information). 

Click IP Application, VRRP and click the Configuration link to display the 
VRRP Configuration screen as shown next. 

Note: You can only configure VRRP on interfaces with unique VLAN IDs.

VR Status

This field displays the status of the virtual router. 

This field is Master indicating that this Switch functions as the master 
router. 

This field is Backup indicating that this Switch functions as a backup 
router.

This field displays Init when this Switch is initiating the VRRP protocol or 
when the Uplink Status field displays Dead. 

Uplink 
Status

This field displays the status of the link between this Switch and the uplink 
gateway. 

This field is Alive indicating that the link between this Switch and the 
uplink gateway is up. Otherwise, this field is Dead. 

This field displays Probe when this Switch is check for the link state. 

Poll 
Interval(s) 

The text box displays how often (in seconds) this screen refreshes. You 
may change the refresh interval by typing a new number in the text box 
and then clicking Set Interval.

Stop

Click Stop to halt system statistic polling.

Table 135   IP Application > VRRP Status  (continued)