Allied Telesis AT-2973T User Manual
Chapter 12: User Diagnostics
156
Overview
Broadcom NetXtreme II User Diagnostics is an MS-DOS based
application that runs a series of diagnostic tests. These tests allow you to
update device firmware as well as to view and change settings for
available adapter properties.
application that runs a series of diagnostic tests. These tests allow you to
update device firmware as well as to view and change settings for
available adapter properties.
To run Broadcom NetXtreme II User Diagnostics, you must create an MS-
DOS 6.22 bootable disk containing the uxdiag.exe file. Next, start the
system with the boot disk in drive A. See the following sections:
DOS 6.22 bootable disk containing the uxdiag.exe file. Next, start the
system with the boot disk in drive A. See the following sections:
For a list of system requirements to run the diagnostic tests, see
“System Requirements” on page 157.
“System Requirements” on page 157.
For instructions how to run diagnostic tests on the AT-2973SX, AT-
2973T, and AT-2973T/4 adapters, see “Performing Diagnostics” on
page 158.
2973T, and AT-2973T/4 adapters, see “Performing Diagnostics” on
page 158.
For descriptions of the available diagnostic tests, see “Diagnostic Test
Descriptions” on page 161.
Descriptions” on page 161.