Allied Telesis AT-2973T User Manual

Chapter 12: User Diagnostics

158

At the MS-DOS prompt, type uxdiag followed by the command options. 

The uxdiag command options are shown in Table 8. For example, to run 
all of the diagnostic tests except Group B tests on adapter #1, enter: 

C:\>uxdiag -c 1 -t b

You must include uxdiag at the beginning of the command string 
each time you type a command. 

Table 8. uxdiag Command Options

uxdiag 

Performs all tests on all Broadcom 
NetXtreme II adapters in your system. 

uxdiag -c <devnum> 

Specifies the adapter (devnum) to test. 
Use all in place of a specific device 
number to test all adapters.

uxdiag -cof 

Allows tests to continue after detecting 
a failure. 

uxdiag -F 

Forces an upgrade of the image 
without checking the version. 

uxdiag -fbc <bc_image> 

Specifies the bin file to update the 
bootcode. 

uxdiag -fib <ib_image> 

Specifies the bin file for iSCSI boot.

uxdiag -fibc

Programs the iSCSI configuration 
block. Used only with -fib <ib_image>.

uxdiag -fibp

Programs the iSCSI configuration 
software. Used only with -fib 
<ib_image>. 

uxdiag -fipmi 
<ipmi_image>

Specifies the bin file to update IPMI 
firmware. 

uxdiag -fmba 
<mba_image>

Specifies the bin file to update the 
MBA.

uxdiag -fncsi 
<ncsi_image> 

Specifies the bin file to update the 
NCSI firmware.