Adtran 1000R Series User Manual
Command Reference Guide
ATM Sub-Interface Config Command Set
61200510L1-35E
Copyright © 2005 ADTRAN
717
ATM S
UB
-I
NTERFACE
C
ONFIG
C
OMMAND
S
ET
To activate the ATM Interface Configuration mode, enter the interface atm command (and specify a
sub-interface) at the Global Configuration mode prompt. For example:
sub-interface) at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface atm 1.1
(config-atm 1.1)#
#configure terminal
(config)#interface atm 1.1
(config-atm 1.1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
of this guide. For more information, refer to the sections listed below:
All other commands for this command set are described in this section in alphabetical order.
dial-backup commands
begin on page 726
ip commands begin on
spanning-tree commands
begin on page 776