Adtran 1000R Series User Manual

Command Reference Guide

61200510L1-35E

Copyright © 2005 ADTRAN

719

Create the access policy that contains the access list InWeb:

(config)#ip policy-class UnTrusted

(config-policy-class)#allow list InWeb

Associate the access list with the ATM 1.1 interface:

(config)#interface atm 1.1

(config-atm 1.1)#access-policy UnTrusted

Creating access policies and lists to regulate traffic through the routed network is a four-step process:

Step 1:

Enable the security features of the AOS using the ip firewall command.

Step 2:

Create an access list to permit or deny specified traffic. Standard access lists provide pattern matching for 
source IP addresses only. (Use extended access lists for more flexible pattern matching.) IP addresses 
can be expressed in one of three ways:

1. Using the keyword any to match any IP address. For example, entering deny any will effectively shut 

down the interface that uses the access list because all traffic will match the any keyword.

2. Using the host <A.B.C.D> to specify a single host address. For example, entering permit host 

196.173.22.253 will allow all traffic from the host with an IP address of 196.173.22.253.

3. Using the <A.B.C.D> <wildcard> format to match all IP addresses in a “range.” Wildcard masks work in 

reverse logic from subnet mask. Specifying a one in the wildcard mask equates to a “don’t care.” For 
example, entering permit 192.168.0.0 0.0.0.255 will permit all traffic from the 192.168.0.0/24 network.

Step 3:

Create an access policy that uses a configured access list. AOS access policies are used to permit, deny, 
or manipulate (using NAT) data for each physical interface. Each ACP consists of a selector (access list) 
and an action (allow, discard, NAT). When packets are received on an interface, the configured ACPs are 
applied to determine whether the data will be processed or discarded. Possible actions performed by the 
access policy are as follows:

allow list <access list names>

All packets passed by the access list(s) entered will be allowed to enter the router system.

discard list <access list names>

All packets passed by the access list(s) entered will be dropped from the router system.

allow list <access list names> policy <access policy name>

All packets passed by the access list(s) entered and destined for the interface using the access policy 
listed will be permitted to enter the router system. This allows for configurations to permit packets to a 
single interface and not the entire system.