Leviton 47611-GB4 User Manual

The 10/100/1000 Mbps 4-Port Gigabit Router is an easy-to-use router that offers small 
office and home office (SOHO) an economical way to connect an entire local area 
network (LAN) to the Internet using an external DSL/Cable Modem.
Follow this Quick-Start Guide to mount the Router into your Structured Media™ Center 
(SMC), and configure it for normal network operation.

To install the Router, you must have the following:
•  A network interface card (NIC) installed in your computer. (Gigabit network card 

required for gigabit speeds to be attained.)

• An external Cable or DSL modem with an RJ-45 port.
•  (4) patch cords with RJ-45 connectors. Leviton Category 5e Performance Patch 

Cords are recommended.

•  A Leviton Category 5e or Category 6 Voice and Data Module located in an SMC.
•  At least 2 Category 5e or Category 6 data connectors (in addition to any desired 

telephone jacks), wired back to the Category 5e Voice and Data Module with 
Category 5e cable. Mark these two connectors and corresponding ports “A” and “B”. 
(Figure 2, page 5)

• An operational Internet connection/ISP.
• A Web browser installed on your computer.
•  Specific ISP information for your broadband connection service; including: type of 

protocol (PPPoE, Dynamic IP, or Fixed IP) and pertinent login information.

NOTE: Category 5e or Category 6 products are required for gigabit operation.

1.  Read and understand all instructions. Follow all warnings and instructions marked 

on the product.

2.  Do not use this product near water—e.g., near a tub, wash basin, kitchen sink or 

laundry tub, in a wet basement, or near a swimming pool.

3.  Never push objects of any kind into this product through openings, as they may 

touch dangerous voltages.

4. SAVE THESE INSTRUCTIONS.

1. Never install communications wiring or components during a lightning storm.
2.  Never install communications components in wet locations unless the components 

are designed specifically for use in wet locations.

3.  Never touch uninsulated wires or terminals unless the wiring has been disconnected 

at the network interface.

4. Use caution when installing or modifying communications wiring or components.

DI-045-47611-05A