Lucent Technologies PortMaster User Manual
Configuration Steps for a Frame Relay Connection
13-10
PortMaster Configuration Guide
Configuring Ethernet Interface Settings
Configure the Ethernet interface settings to the values shown in Table 13-4.
After you configure the Ethernet interface as shown in Table 13-4, enter the following
command to save the configuration:
command to save the configuration:
Command> save all
For more information on Ethernet parameters, refer to Chapter 4, “Configuring the
Ethernet Interface.”
Ethernet Interface.”
Configuring Synchronous WAN Port Settings
Configure the synchronous WAN port W1 to the values shown in Table 13-5.
Table 13-4
Ethernet Values
Setting
Command
IP address
set ether0 address 92.168.1.1
Netmask
set ether0 netmask 255.255.255.0
Broadcast address
set ether0 broadcast high
RIP routing
set ether0 rip on
Table 13-5
WAN Port Parameter Values
Setting
Command
Port type
set w1 network hardwired
Protocol
set w1 protocol frame
Port IP address
set w1 address 92.168.1.20.2
Netmask
set w1 netmask 255.255.255.0
Modem control
set w1 cd on
RIP routing
set w1 rip listen
Annex-D
set w1 annex-d 10
(LMI can be used instead of Annex-D)