Lucent Technologies PortMaster User Manual
Configuration Steps for a Synchronous V.25bis Connection
14-10
PortMaster Configuration Guide
Configuring a Dial-In User
A user account must be set up on the PortMaster router in Miami so the PortMaster in
Boston can dial in when traffic is queued. The new user boston should be configured on
the PortMaster in Miami with the values shown in Table 14-9.
Boston can dial in when traffic is queued. The new user boston should be configured on
the PortMaster in Miami with the values shown in Table 14-9.
No compression is used on synchronous lines.
After you configure user table settings as shown in Table 14-9, enter the following
command to save the configuration:
command to save the configuration:
Command> save all
For more information about configuring user table parameters, refer to Chapter 7,
“Configuring Dial-In Users.”
“Configuring Dial-In Users.”
Table 14-9
User Table Values for Miami
Setting
Command
Username
add netuser boston
Password
set user boston password anypasswd
Protocol
set user boston protocol ppp
User IP address
set user boston address 192.168.200.1
Netmask
set user boston netmask 255.255.255.0
IPX network
set user boston ipxnet F3
RIP routing
set user boston rip on
MTU
set user boston mtu 1500