NEC NWA-008869-001 User Manual
CHAPTER 4 INITIALIZATION
– 104 –
NWA-008869-001 Rev.1.0
atch4001.fm
SETTING UP THE WAN PRIVATE LINE (T1)
You can connect the In-Skin Router (PZ-M649 card is required) to a digital private line (T1).
To do this, use the following procedure.
(1) Set line attributes for a T1 Line
(2) Shutting down and restarting the interface for the settings to take effect
(3) Save setting data
(4) Check the status of interface
To do this, use the following procedure.
(1) Set line attributes for a T1 Line
(2) Shutting down and restarting the interface for the settings to take effect
(3) Save setting data
(4) Check the status of interface
Setting line attributes for a T1 Line
Set the line attributes of a T1 line if necessary.
The line attributes you can set are a type (default: b8zs) of line code (b8zs/ami), lbo (default: 0 [db]/0 to
132 [feet]), and the number of time slots for T1 (default: 12 time slots).
If you use default settings, you do not need to perform these settings.
To set line attributes of a T1 line, use the Serial0 in device config mode.
The line attributes you can set are a type (default: b8zs) of line code (b8zs/ami), lbo (default: 0 [db]/0 to
132 [feet]), and the number of time slots for T1 (default: 12 time slots).
If you use default settings, you do not need to perform these settings.
To set line attributes of a T1 line, use the Serial0 in device config mode.
For details, refer to “Router Command Reference Manual”.
NOTE:
If you change a line attribute of a T1 line to another, you must shut down and restart the inter-
face for the change to take effect.
face for the change to take effect.
ix1000
− 01 # enable − config
ix1000
− 01 (config) # device Serial0
ix1000
− 01 (config − Serial0) #
Enter
Enter
SETTING UP THE WAN PRIVATE LINE (T1)