NEC NWA-008869-001 User Manual
CHAPTER 4 INITIALIZATION
– 105 –
NWA-008869-001 Rev.1.0
atch4001.fm
Shutting down and restarting the interface for the settings to take effect
If you change a line attribute of a T1 line, you must shut down and restart the interface for the change to
take effect.
To shut down and restart the interface, use the Serial0.0 in device config mode.
To stop the interface operation, use shutdown, and to restart it, use no shutdown.
If setting was changed after shutdown, only no shutdown is necessary.
take effect.
To shut down and restart the interface, use the Serial0.0 in device config mode.
To stop the interface operation, use shutdown, and to restart it, use no shutdown.
If setting was changed after shutdown, only no shutdown is necessary.
If setting was changed after shutdown, only no shutdown is necessary.
Saving setting data
Upon completion of setting, use the write memory command to save as startup config the data that you
have set before a restart.
have set before a restart.
NOTE:
Do not turn OFF the power switch while the BUSY lamp is lit. Otherwise, the data in flash mem-
ory may be destroyed.
ory may be destroyed.
Checking the status of interface
Check the status of interface by show interface command.
ix1000
− 01 # enable − config
ix1000
− 01 (config) # interface Serial0.0
ix1000
− 01 (config − Serial0.0) # shutdown
ix1000
− 01 (config − Serial0.0) # no shutdown
ix1000
− 01 (config − Serial0.0) #
Enter
Enter
Enter
Enter
ix1000
− 01 (config − Serial0.0) # exit
ix1000
− 01 (config) # write memory
ix1000
− 01 (config) #
Enter
Enter
ix1000
− 01 # enable − config
ix1000
− 01 (config) # show interfaces Serial0.0
Interface Serial0.0 is up
(Omitted)
ix1000
− 01 (config) #
Enter
Enter
Check that "up" is
displayed.
SETTING UP THE WAN PRIVATE LINE (T1)