Nortel Networks 1005r User Manual
Using Windows online diagnostic tools
Standard 1.10
52
CallPilot
Tracert syntax
The tracert command uses the following syntax:
The tracert command uses the following syntax:
tracert [-d] [-h maximum_hops] [-j host_list]
[-w timeout] [target_name]
Tracert parameters
The following table shows the tracert parameters.
The following table shows the tracert parameters.
Table 6: Tracert parameters
To run the tracert command from Windows
1
Click Start > Programs > Accessories > Command Prompt.
Result: The Command Prompt dialog box appears.
2
Type the following command:
tracert [-d] [-h maximum_hops] [-j host_list] [-w timeout]
[target_name]
[target_name]
Example: tracert 200.286.0.32
3
Press Enter.
Parameter
Description
-d
Specifies not to resolve addresses to host names.
-h maximum_hops Specifies the maximum number of hops to search
for the target.
-j host-list
Specifies a loose source route along the host list.
-w timeout
Waits the number of milliseconds specified by the
timeout for each reply.
timeout for each reply.
target_name
Specifies the name of the target host.