Siemens S223 User Manual
UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
108 A50010-Y3-C150-2-7619
To display a granted an SNMP group to access a specific SNMP view record, use the fol-
lowing command.
lowing command.
Command Mode
Description
show snmp access
Enable
Global
Shows a granted an SNMP group to access a specific
SNMP view record
SNMP view record
The following is an example of permission to accessing an SNMP view record.
SWITCH(config)#
SWITCH(config)# snmp access regroup v1 test none none
SWITCH(config)# show snmp access
Access List
GroupName SecModel SecLevel ReadView WriteView NotifyView
------------------------------------------------------------------------------
rogroup v1 noauth TEST none none
SWITCH(config)#
7.1.7
SNMP Version 3 User
In SNMP version 3, you can register an SNMP agent as user. If you register SNMP ver-
sion 3 user, you should configure it with the authentication key.
sion 3 user, you should configure it with the authentication key.
To create/delete SNMP version 3 user, use the following command.
Command Mode
Description
snmp
user USER {md5 | sha}
AUTH-KEY
[des PRIVATE-KEY]
Creates SNMP version 3 user.
USER : enters user name
AUTH-KEY: Authentication passphrase (min length:8)
PRIVATE-KEY: Privacy passphrase (min length: 8)
USER : enters user name
AUTH-KEY: Authentication passphrase (min length:8)
PRIVATE-KEY: Privacy passphrase (min length: 8)
no
snmp user USER
Global
Deletes a registered SNMP version 3 user.
To display SNMP version 3 user, use the following command.
Command Mode
Description
show snmp user
Enable
Global
Displays SNMP version 3 user.
7.1.8 SNMP
Trap
SNMP trap is an alert message that SNMP agent notifies SNMP manager about certain
problems. If you configure SNMP trap, switch transmits pertinent information to network
management program. In this case, trap message receivers are called trap host.
problems. If you configure SNMP trap, switch transmits pertinent information to network
management program. In this case, trap message receivers are called trap host.