Siemens S223 User Manual

User Manual                                                                               UMN:CLI 
SURPASS hiD 6615 S223/S323 R1.5 

A50010-Y3-C150-2-7619                                                                         197 

The port configured as member port is basically configured to aggregate to LACP. How-
ever, even though the configuration as member port is not released, they could operate 
as independent port without being aggregated to LACP. These independent ports cannot 
be configured as trunk port because they are independent from being aggregated to 
LACP under the condition of being configured as member port. 

To configure member port to aggregate to LACP, use the following command. 

  PORTS 

{aggregatable | individual} 

Bridge 

Designates whether a member port joins LACP or not, 
select the member port should be included. (default: 
aggregatable) 

 

To clear aggregated to LACP of configured member port, use the following command. 

no lacp port aggregation PORTS

Bridge 

Deletes the configured member port in LACP, select 
the member port. 

 

Member port transmits BPDU with its information. For the hiD 6615 S223/S323, it is pos-
sible to configure the BPDU transmission rate, use the following command. 

 PORTS {short | 

} 

Bridge 

Configures BPDU transmission rate: 
PORTS: select the port number. 
short: fast rate (once every 1 sec) 
long: slow rate (30 sec: default) 

 

To clear BPDU transmission rate, use the following command (clear means long timeout). 

 PORTS Bridge 

Deletes BPDU transmission rate of configured member 
port, select the port number. 

 

Member port of LACP has key value. All member ports in one aggregator have same key 
values. To make an aggregator consisted of specified member ports, configure different 
key value with key value of another port. 

  PORTS <1-

15> 

Bridge 

Configures key value of member port: 
PORTS: select the port number. 
1-15: select the port key value. (default: 1)