Siemens S223 User Manual

User Manual                                                                               UMN:CLI 
SURPASS hiD 6615 S223/S323 R1.5 

A50010-Y3-C150-2-7619                                                                         195 

•

 

•

 

•

 

•

 

•

 

Identifying Member Ports within LACP 

•

 

BPDU Transmission Rate 

•

 

•

 

•

 

 

Step 1 
Activate LACP function, using the following command. 

 

Enables LACP of designated Aggregator-number: 
AGGREGATIONS: select aggregator ID that should be 
enabled for LACP (valid value from 0 to 13). 

   

 

Bridge 

Disables LACP for designated Aggregator-number, 
select the aggregator ID that should be disabled for 
LACP. 

 

 

Step 2 
Configure the physical port that is a member of aggregated port. In order to configure the 
member port, use the following command. 

 PORTS 

Configures physical port that is member port of aggre-
gator; select the port number(s) that should be enabled 
for LACP. 

no lacp port PORTS 

Bridge 

Deletes member port of Aggregator, select the port 
number(s) that should be disabled for LACP. 

 

When packets enter to logical port integrating several ports, if there’s no process to de-
cide the packet route, it is not possible to use logical port effectively from focusing pack-
ets on a particular member port. 

If these packets enter to logical port aggregating several ports and there’s no way to de-
cide packet route, the packets could be gathered on particular member port so that it is 
not possible to use logical port effectively. 

Therefore the hiD 6615 S223/S323 is configured to decide the way of packet route in or-
der to divide on member port effectively when packets are transmitted. It can be selected 
with Source IP address, destination IP address, source MAC address, destination MAC 
address and the user could get the information of packets to decided packet route.