Siemens S223 User Manual

User Manual                                                                               UMN:CLI 
SURPASS hiD 6615 S223/S323 R1.5 

A50010-Y3-C150-2-7619                                                                         369 

To add the value of routing metrics, use the following command. 

offset-list ACCESS-LIST 

{in | out} 

<0-16> [INTERFACE] 

Router 

Add an offset to incoming or outgoing metrics to routes 
learned via RIP. 
ACCESS-LIST: access list name 
0-16: type number 
INTERFACE: interface name 

 

no offset-list ACCESS-LIST

  {in | 

} <0-16> [INTERFACE] 

Router 

Removes an offset list. 

 

You can set the maximum number of RIP routes for using on RIP protocol. To set the 
maximum number of routes, use the following command.   

<1-65535> [1-

100] 

Sets the maximum number of routes of RIP. 
1-65535: maximum number of RIP routes 
1-100: percentage of maximum routes to generate a 
warning (default: 75) 

<1-65535> 

[1-100] 

Router 

Removes the maximum number of routes of RIP which 
are set before. 

 

Routing protocols use several timers that determine such variables as the frequency of 
routing updates, the length of time before a route becomes invalid, and other parameters. 
You can adjust these timers to tune routing protocol performance to better your internet 
needs. The default settings for the timers are as follows. 

•

 

The routing information is updated once every 30 seconds. This is the fundamental 

 

timing parameter of the routing protocol. Every update timer seconds, the RIP proc-

 

ess is supposed to send the routing table to all neighboring RIP routers. 

•

 

 

The default is 180 seconds. It’s the interval of time in seconds after which a route is 

 

declared invalid. However, this information will be still written in routing table until the 

 

neighbor routers are notified that this route is removed from the routing table.   

•

 

 

The invalid information of route is deleted on the routing table every 120 seconds. 

 

Once the information of route is classified as “invalid”, it’s eventually removed from 

 

the routing table after 120 seconds.