Siemens S223 User Manual

User Manual                                                                               UMN:CLI 
SURPASS hiD 6615 S223/S323 R1.5 

A50010-Y3-C150-2-7619                                                                         371 

To configure RIP authentication, use the following command. 

 

Enables authentication for RIP v2 packets and to spec-
ify the set of keys that can be used on an interface. 
NAME: name of key chain 

 {text | 

} 

Interface 

Specifies the authentication mode. 
text: sends a simple text password to neighbors. If a 
neighbor does not have the same password, request 
and updates from this system are rejected. 
md5: sends an MD5 hash to neighbors. Neighbors 
must share the MD5 key to decrypt the message and 
encrypt the response. 

 

 

Interface 

Configures RIP authentication string which will be us-
ing on interface without Key chain. The string must be 
shorter than 16 characters. 
STRING: RIP authentication string 

 

To disable RIP authentication, use the following command. 

chain NAME

 

Disables authentication keys that can be used on an 
interface. 

 

{text | md5} 

Disables specified authentication mode. 

 

 

Interface 

Removes RIP authentication string which will be using 
on interface without Key chain. 

 

Occasionally, you should restart RIP system only when the switch is still operating while 
you manage and configure RIP. At this time, the switch reports the neighbors that RIP 
system is being restarting. It keeps previous route information until the restarting is com-
plete in timer.     

To restart RIP system only, use the following command. 

<1-65535> 

Restarts RIP system and set the period. 

[<1-65535>] 

Global 

Removes a configured period. 

 

RIP protocol exchanges the routing information between routers using UDP packets. The 
hiD 6615 S323 can be configured theses UDP packets buffer size, use the following