Siemens 5890 User Manual

Easy Setup

This chapter describes how to define router configuration settings using the Easy Setup Wizard. These 
settings control access to the Wide Area Network (WAN) and Local Area Network (LAN). During the Easy 
Setup procedure, you will be prompted to specify configuration parameters that may require information from 
your service provider.

To access the Easy Setup Wizard, click Easy Setup in the left navigation pane of the Router Information 
window. This wizard will walk you through the configuration screens necessary to setup the router. You can 
exit the Easy Setup Wizard at anytime by clicking Cancel on the bottom of the configuration page. If the wizard 
is cancelled, no changes will be made and you will need to begin again. 

When you click Easy Setup in the left navigation 
pane of the Router Information page, the WAN 
Interface page is displayed. This page is used to 
enter and review information about Wide Area 
Network (WAN) settings.

To configure the WAN interface:

1. In Data PVC, enter the ATM Permanent Virtual 

Circuit (PVC) information: VPI / VCI. 

2. From the Wan Protocol list, select the protocol 

to use for the WAN connection.

3. Click Next to continue. This displays the page 

required to configure the selected protocol. In 
the list below, click on the protocol you 
selected to jump to the appropriate page.

Point-to-Point Protocol over Ethernet over PPPoA