Siemens S323 User Manual

User Manual                                                                               UMN:CLI 
SURPASS hiD 6615 S223/S323 R1.5 

A50010-Y3-C150-2-7619                                                                         33 

To open Interface Configuration mode, enter the command, interface  INTERFACE, on 
Global Configuration

 mode, and then the prompt is changed from SWITCH(config)# to 

SWITCH(config-if)#. 

 INTERFACE Global 

Opens 

mode. 

 

 mode is to assign IP address in Ethernet interface and to activate 

or deactivate interface. 

Tab. 3.8 shows a couple of main commands of Interface Configuration mode. 

Configures bandwidth used to make routing information. 

Makes description of interface. 

Assigns IP address. 

Deactivates interface. 

Sets MTU value to interface. 

Main Commands of Interface Configuration Mode 

 

To open RMON-Alarm Configuration mode, enter rmon-alarm <1-65534>. To open 
RMON-Event Configuration

 mode, input rmon-event <1-65534>. And to open RMON-

 mode, enter rmon-history <1-65534>.   

Tab. 3.9 shows a couple of important main commands of RMON Configuration mode. 

Enables each RMON configuration. 

Configures password for trap message transmission right. 

Describes the RMON event. 

Configures to generate RMON alarm when object is less than config-
ured threshold. 

Defines the falling threshold 

Shows the subject, which configures each RMON and uses related 
information. 

Configures to generate RMON alarm when object is more than config-
ured threshold. 

Defines a bucket count for the interval. 

Main Commands of RMON Configuration Mode