Siemens S323 User Manual
User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5
SURPASS hiD 6615 S223/S323 R1.5
A50010-Y3-C150-2-7619 89
To show a configured threshold of CPU load, use the following command.
Command Mode
Description
show cpuload
All
Shows a configured threshold of CPU load.
6.1.12.2 Port
Traffic
To set a threshold of port traffic, use the following command.
Command Mode
Description
threshold port
PORTS
THRESHOLD
{5 | 60 | 600} {rx |
tx
}
Sets a threshold of port traffic.
PORTS: port number (1/1, 1/2, 2/1, …)
THRESHOLD: threshold value (unit: kbps)
5 | 60 | 600: time Interval (unit: second)
PORTS: port number (1/1, 1/2, 2/1, …)
THRESHOLD: threshold value (unit: kbps)
5 | 60 | 600: time Interval (unit: second)
no threshold port
PORTS {rx |
tx
}
Global
Deletes a configured threshold of port traffic.
The threshold of the port is set to the maximum rate of the port as a default.
To show a configured threshold of port traffic, use the following command.
Command Mode
Description
show port threshold
Enable
Global
Shows a configured threshold of port traffic.
6.1.12.3 Fan
Operation
The system fan will operate depending on a configured fan threshold. To set a threshold
of port traffic, use the following command.
of port traffic, use the following command.
Command Mode
Description
threshold fan
START-TEMP
STOP-TEMP
Sets a threshold of fan operation in the unit of centi-
grade (°C).
START-TEMP: starts fan operation. (default: 30)
STOP-TEMP: stops fan operation. (default: 0)
grade (°C).
START-TEMP: starts fan operation. (default: 30)
STOP-TEMP: stops fan operation. (default: 0)
no threshold fan
Global
Deletes a configured threshold of fan operation.
When you set a threshold of fan operation, START-TEMP must be higher than STOP-
TEMP
TEMP
.
To show a configured threshold of fan operation, use the following command.
Command Mode
Description
show status fan
Enable /Global / Bridge
Shows a status and configured threshold of fan opera-
tion.
tion.
i
!