Proxim AP-2500 User Manual
205
Using the Command Line Interface
Parameter Tables
Objects contain groups that contain both parameters and parameter tables.
Use the following Tables to configure the Access Point. The Access Point CLI is under development as this document
is being prepared; therefore, some table cells are blank where a feature has not yet been implemented or information
needs validation. Columns used on the tables include:
Use the following Tables to configure the Access Point. The Access Point CLI is under development as this document
is being prepared; therefore, some table cells are blank where a feature has not yet been implemented or information
needs validation. Columns used on the tables include:
— Name - Parameter, Group, or Table Name
— Type - Data type
— Values - Value range, and default value, if any
— ACC. - Indicates access type. R = Read Only (show), RW = Read-Write, can be "set", W = Write Only
— CLI Parameter - Parameter name as used in the Access Point
— Type - Data type
— Values - Value range, and default value, if any
— ACC. - Indicates access type. R = Read Only (show), RW = Read-Write, can be "set", W = Write Only
— CLI Parameter - Parameter name as used in the Access Point
Access Point network objects are associated with Groups. The network objects are listed below and associated
parameters are described in the following Parameter Tables:
•
parameters are described in the following Parameter Tables:
•
- Access Point system information
•
•
•
- IP, DHCP, DNS and VLAN configuration
•
•
•
•
•
(including WDS)
•
•
•
- Control access to the AP-2500’s management interfaces and set the time
•
•
•
•
•
•
•
•
- Access Point security settings and RADIUS configuration
•
•
•
•
- Configure Authentication, Authorization and Accounting (AAA) settings
•
•
•
•
- System and AAA Logging
•
- Prevent subscribers from accessing specified Web sites
•
•
•
- Configure the Information and Control Console
•
•
•
- Enable redirection of outgoing e-mails