Proxim AP-2500 User Manual
207
Using the Command Line Interface
Inventory Management Information
NOTE
The inventory management commands display advanced information about the AP’s installed components.
You may be asked to report this information to a technical representative if you contact customer support.
You may be asked to report this information to a technical representative if you contact customer support.
Network Parameters
NOTE
The IP Address Assignment Type (ipaddrtype) must be set to static before the IP Address (ipaddr), IP Mask
(ipsubmask) or Default Gateway IP Address (ipgw) values can be entered.
(ipsubmask) or Default Gateway IP Address (ipgw) values can be entered.
Location Parameters
You can also configure the AP’s basic IP settings using the following Location parameters:
Name
Type
Values
Access CLI Parameter
System Inventory Management
Subgroup
N/A
R
sysinvmgmt
Component Table
Subgroup
N/A
R
sysinvmgmtcmptbl
Component Interface Table
Subgroup
N/A
R
sysinvmgmtcmpiftbl
Name
Type
Values
Access CLI Parameter
Network
Group
N/A
R
network
IP Configuration
Group
N/A
R
ip (Note: The network and
ip parameters display the
same information)
ip parameters display the
same information)
IP Address
IpAddress
User Defined
RW
ipaddr
IP Mask
IpAddress
User Defined
RW
ipmask
Default Router IP Address
IpAddress
User Defined
RW
ipgw
Default TTL
Integer
User Defined
64 (default)
64 (default)
RW
ipttl
Address Type
Integer
static
dynamic (default)
dynamic (default)
RW
ipaddrtype
Name
Type
Values
Access
CLI Parameter
Location
Group
N/A
R
location
Network IP Address
IpAddress
User Defined
RW/Reboot
locationNetworkIp
Network Subnet
Mask
Mask
DisplayString
Size(0..238)
Size(0..238)
User Defined
RW/Reboot
locationNetmask
Gateway IP Address
IpAddress
User Defined
RW/Reboot
locationGateway